From laptop A, I am able to connect with RDP to server B both on IP. From laptop A, Im not able to connect with RDP to server A on IP address (the IP address is correct). Please Note: Since the web site is not hosted by Microsoft, the link may change without notice. Both servers have a GPO from the domain controller that enables NLA (Network Level Authentication). If this 'router' has WAN port IP address for, you have two 'routers' that are using NAT services. Then set the path for data folder, log file and ip bind using the below command. There are some IP address schemes that you can not access over the Internet: 192.168.0.xxx -> 10.0.0.xxx -> 10. The Internet 'static' IP address needs to arrive to the 'port forwarding' controlling router. If don't, ask to net admin/ DHCP server admin to check and fix the issue - is a problem on the DHCP server If you have a DNS Ip address. No matter how your computers are connected to the Internet and if they are. Check again if you received friom the DHCP server a DNS server IP address. #Litemanager not able to connect with ip address Pc#If you already running the MongoDB service then run this command or else, go to second point. You will be able to take control of the remote partner PC in a couple of seconds. Here is similar thread discussed before, you could have a look: First open the cmd as administrator and go to -YourPath-\MongoDB\Server\4.0\bin. What's the error message when you can't connect to file server with IP address ? Please post the detailed error message for us to troubleshooting.Ĭould you ping the server IP address when you can't connect to file server with IP address ? If you can ping the server IP successfully, this is might not be a network problem. > some clients can't connect to file server with IP address, but with FQDN. Note: since this is a public forum, everyone could view your information, please remove private information that might leak your privacy. Only if You will use direct IP connection by IP address, then need open LM Server port by default 5650. It would be helpful for us to identify the problem if you could upload the results. For connection by ID the port forwarding is not needed. Then check the IP address what you get back is correct. Open a connection via ID of the program server module you can using the context menu the server icon or using the menu Start The settings of the program LiteManager Remove the mark from the point use shared NOIP and specify the IP address and the port of your computer, then the only thing left is to connect. Please first run "nslookup" and type in the server FQDN. Before going further, I would appreciate your help in clarifying the following situations: I have a di-604 connected to a cable modem (suddenlink internet).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |